![]() I somehow bricked my HD10, I think I disconnected the USB because I was to unpatient.įor the Hardware method, you need to open the Tablet, use a prytool or a Creditcars / Knife to remove the backcover, just gently pry around the bezel until the screen pops out. If you got stuck somewhere in the middle or the Exploit doesn’t work try the hardware method. In TWRP Format Data and Wipe data, system, cache. Prepare a Micro SD Card with: Lineage OS (Search the forum for the douglas (FireHD 8 7.Gen) or suez (FireHD 10 7Gen) Version, Gapps (ARM64, 7.1, nano) and Magisk and insert in FireHD. Wait until the bootrom step is finished.Check Display output for the “Disconnect usb and powerdown” message and do so when prompted.Open Terminal from “brick-douglas” folder.If theres an error let the FireHD Reboot and do the “Apps and Data Optimization” at the Welcome Install Screen Powerdown the FireHD and enter Bootloader again. Open Terminal from “amonet-douglas-v1.2” foder.Check Display output for the “Disconnect USB and Powerdown” Message and do so when prompted.Open Terminal from “brick-douglas” folder an enter “sudo.You will see the balck screen with “Fastboot” in the lower corner.Reboot FireHD8 to Recovery (Power Off device, then hold VolUp + Power). ![]() Unpack and copy to the MTK-su from the 64 Bit folder to the “bin” folders of the previous unpacked folders. Did you enter bootloader mode on the Fire ? Powerdown and then Press VolUp + Power, wait until you see "Enter Recovery", then select "Bootloader".Īmonet-douglas-v1.2.zip from first Page of this Thread:īrick-douglas.zip from first Page of this Thread:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |